AMS1117-5.0 V Regulator Module

A small linear regulator module that turns a higher input voltage into a steady 5.0 V, up to 800 mA.

AMS1117-5.0V Regulator Module

At a glance

Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.

Pinout

Pinout of the AMS1117-5.0V Regulator Module, drawn as in the circuit editor. Select a label to see that pin in the table below.

Properties

What you can change in the Property Inspector.

Properties of this part
PropertyRange or choicesDefault
Output Voltage (Vout)4.9 to 5.1 V5 V
Dropout Voltage1 to 1.5 V1.2 V
Cooling / Thermal RatingBreakout PCB (Pmax ≈ 0.8 W), With Small Heatsink (Pmax ≈ 1.5 W)Breakout PCB (Pmax ≈ 0.8 W)
Max Rated Current0.2 to 1 A0.8 A

The AMS1117-5.0 module turns a higher input voltage (for example 9 V from a battery) into a steady 5 V output. It is a linear regulator: the difference between input and output is turned into heat.

Pins

Pins of this part
PinLabelTypeNotes
vinVINPower inInput voltage (above 5 V plus the dropout)
gnd_inGNDGroundGround (two pins, connected together)
voutVOUTPower outRegulated 5 V output
gnd_outGNDGroundGround (two pins, connected together)

Things to know

  • Dropout: the input must be at least the dropout voltage (about 1.2 V by default) above the output, so 6.2 V or more.
  • Heat: the lost power is (VIN - VOUT) x current. On this breakout board about 0.8 W can be dissipated without a heatsink, which is about 800 mA at 7 to 9 V in. A 12 V input at the same current is too much: use a lower input or a switching module.
  • Maximum current: 800 mA by default.

Properties

Output voltage, dropout voltage, cooling rating and maximum current can be changed in the Properties panel.

Typical use

A 7 to 9 V battery on VIN, the 5 V rail of the circuit on VOUT, grounds joined.

AMS1117-5.0 V Regulator Module — OMS Parts