The AMS1117-3.3 module turns an input voltage (for example 5 V from USB or a battery) into a steady 3.3 V output for boards and sensors that need it. It is a linear regulator: it burns off the voltage difference as heat.
AMS1117-3.3 V Regulator Module
A small linear regulator module that turns a higher input voltage into a steady 3.3 V, up to 800 mA.

At a glance
Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.
Pinout
Properties
What you can change in the Property Inspector.
| Property | Range or choices | Default |
|---|---|---|
| Output Voltage (Vout) | 3.25 to 3.35 V | 3.3 V |
| Dropout Voltage | 1 to 1.5 V | 1.2 V |
| Cooling / Thermal Rating | Breakout PCB (Pmax ≈ 0.8 W), With Small Heatsink (Pmax ≈ 1.5 W) | Breakout PCB (Pmax ≈ 0.8 W) |
| Max Rated Current | 0.2 to 1 A | 0.8 A |
| Pin | Label | Type | Notes |
|---|---|---|---|
vin | VIN | Power in | Input voltage (must be above 3.3 V plus the dropout) |
gnd_in | GND | Ground | Ground (two pins, one on each side, connected together) |
vout | VOUT | Power out | Regulated 3.3 V output |
gnd_out | GND | Ground | Ground (two pins, one on each side, connected together) |
Things to know
- Dropout: the input must be higher than the output by at least the dropout voltage (about 1.2 V by default), so at least 4.5 V in. Lower than that and the output falls below 3.3 V.
- Heat: power lost as heat is (VIN - VOUT) x current. The module can dissipate about 0.8 W without a heatsink, which is roughly 800 mA at 7 to 9 V in, and much less at higher input voltages. The simulator shows an overload when the part is pushed past its rating.
- Maximum current: 800 mA by default (a property).
Properties
Output voltage, dropout voltage, cooling rating and maximum current can be changed in the Properties panel to try other regulators or conditions.
Typical use
A 5 V supply to VIN and the 3V3 rail of a circuit to VOUT, with the grounds joined. Do not connect VOUT to another supply output.
Related parts
- AMS1117-5.0 V Regulator ModuleA small linear regulator module that turns a higher input voltage into a steady 5.0 V, up to 800 mA.
- LM317 Adjustable RegulatorThe LM317 is a three-pin regulator whose output voltage you set with two resistors, from 1.25 V up to 37 V at 1.5 A.
- LM7805 5 V RegulatorThe LM7805 is the classic three-pin regulator: any input from about 7 V up gives a steady 5 V at up to 1.5 A.
- LM7812 12 V RegulatorThe LM7812 is a three-pin regulator that gives a steady 12 V at up to 1.5 A from an input of about 14 V or more.
- MT3608 Boost Converter ModuleThe MT3608 module raises a low voltage to a higher one (3 V to 28 V out from 2 V to 24 V in) with an adjustable output.
