The MT3608 is a step-up (boost) DC-DC converter module. It takes a low input voltage, such as a single battery cell or 5 V from USB, and produces a higher output voltage you adjust with the small trimmer on the board, from 3 V up to 28 V. Unlike a linear regulator it switches rapidly and wastes little as heat.
Pins
| Pin | Use |
|---|---|
| VIN+ and VIN- | Input voltage and its ground (2 V to 24 V) |
| VOUT+ and VOUT- | Boosted output and its ground |
Things to know
- The output must be higher than the input. A boost converter cannot lower the voltage.
- Input current is bigger than output current. Power in is about equal to power out, so at 5 V in and 12 V out the input current is more than twice the output current (plus losses). Size the source for that.
- Maximum current: 2 A for the module; the simulator default is 1.5 A. Heating grows with load and depends on the cooling rating.
- Set the output before connecting a load, because the trimmer is often at an unknown position.
Properties
Target boost voltage (3 V to 28 V), cooling rating and maximum current are in the Properties panel; the output trimmer on the part can also be dragged during a simulation.

