LM2596 Buck Converter Module

The LM2596 module brings a higher voltage down to a lower one (1.3 V to 30 V out from 4.5 V to 40 V in) and wastes much less power than a linear regulator.

LM2596 Buck Converter Module

At a glance

Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.

Pinout

Pinout of the LM2596 Buck Converter Module, drawn as in the circuit editor. Select a label to see that pin in the table below.

Pins

Pins of this part
PinLabelType
vinIN+Power in
gnd_inIN-Ground
voutOUT+Power out
gnd_outOUT-Ground

Properties

What you can change in the Property Inspector.

Properties of this part
PropertyRange or choicesDefault
Target Output Voltage (Vout)1.3 to 30 V5 V
Cooling / Thermal RatingNatural Convection (Max ~1.2W dissipation), With Heat Sink (Max ~2.5W dissipation)Natural Convection (Max ~1.2W dissipation)
Max Rated Current0.2 to 3 A3 A

The LM2596 module is a step-down (buck) DC-DC converter. It takes a higher voltage, such as 12 V from an adapter or 9 V from a battery, and produces a lower output voltage that you adjust with the small trimmer on the board. Unlike a linear regulator such as the LM7805, it switches rapidly and wastes little as heat, about 15 percent of the output power.

Pins

PinUse
VIN+Input voltage (4.5 V to 40 V, at least about 1.5 V above the output)
VIN-Input ground (joined to VOUT- on the board)
VOUT+Regulated output voltage
VOUT-Output ground

Things to know

  • Less current in than out: because the input voltage is higher than the output, the module takes less current from the supply than it gives to the load (power in is only about 18 percent more than power out).
  • Dropout: the input must be about 1.5 V above the output. Below that, the output follows the input minus 1.5 V. Below about 4 V the module does not start.
  • Maximum current: 3 A by default.

Properties

Target output voltage (1.3 V to 30 V), cooling rating and maximum current are in the Properties panel; the output trimmer on the part can also be dragged during a simulation.

Typical use

A 12 V adapter on VIN, a steady 5 V on VOUT for a microcontroller board, with the two grounds joined.

LM2596 Buck Converter Module — OMS Parts