This is a standard 16-column, 2-row character display with the AIP31068 controller. The controller understands the usual HD44780 display commands and has I2C built into the chip, so the module needs only four wires. It is a different part from the common 16x2 display with a PCF8574 backpack: there is no expander chip, and the I2C address is fixed at 0x3E.
LCD 16x2 (I2C, AIP31068)
A 16x2 character display whose controller speaks I2C itself: four wires, fixed address 0x3E, no expander chip.
Displays9 blocksMicroPythonC++

At a glance
Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.
Pinout
| Pin | Label | Type | Notes |
|---|---|---|---|
GND | GND | Ground | GND |
VCC | VCC | Power in | 3.3 V or 5 V, as the module is rated |
SDA | SDA | Bidirectional | The board's I2C data pin |
SCL | SCL | Signal in | The board's I2C clock pin |
The display shows text only once a program running on the board actually sends data over I2C: with nothing sending, it stays blank (like the real part).
Blocks
Drawing the blocks…
Troubleshooting
- A blank screen: check SDA and SCL are on the board's I2C pins and that the setup block runs first.
- Text in the wrong place or missing: check that the row and column you gave are inside the display (2 rows, 16 columns).
- It does not answer on a real board: confirm the module really uses the AIP31068 (address 0x3E); modules with a PCF8574 backpack use another address and another part.
Related parts
- LCD 16x2 Display (I2C)Powered state comes from VCC: above 3.0V the backlight and text render; below 4.5V while powered, a LOW VCC fault is raised.
- LCD 16x2 Display (Parallel)> [!NOTE] > OMS's simulated component models all 16 pins for visual accuracy, but every real driver (the Arduino LiquidCrystal library, and the MicroPython bit-bang port below) only ever…
