Inductor

An inductor is a passive component that stores energy in a magnetic field when current flows through it, resisting sudden changes in current.

Inductor

At a glance

Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.

Pinout

Pinout of the Inductor, drawn as in the circuit editor. Select a label to see that pin in the table below.

Pins

Pins of this part
PinLabelType
AABidirectional
BBBidirectional

Properties

What you can change in the Property Inspector.

Properties of this part
PropertyRange or choicesDefault
Inductance0.000001 to 10 H0.001 H

An inductor is a passive component that stores energy in a magnetic field when current flows through it, resisting sudden changes in current. In Open Maker Studio, it does not have Blockly code blocks — it interacts directly with the real-time SPICE analog simulator, most commonly for filtering and energy-storage roles (buck/boost converters, LC filters, flyback snubbers).


1. Schematic Symbol

Standard coil symbol:

A B

2. Characteristics & Behavior

  • At true DC steady-state, an ideal inductor behaves as a short circuit (zero resistance) — matches OMS's real component description exactly.
  • Real-world limitation: OMS's inductor has no fault modeling at all (faults: [], empty) — no core saturation, no overcurrent, no flyback voltage-spike simulation. It's a pure, ideal SPICE inductor element with no failure modes, unlike the Resistor/LED/Capacitor which do model at least one fault type. Don't rely on it to demonstrate real-world inductor failure behavior.

3. Core Calculations & Math

  • Voltage-Current Relationship: V=LdIdtV = L \frac{dI}{dt}

the voltage across an inductor is proportional to the rate of change of current through it, not the current itself.

  • Energy Stored: E=12LI2E = \frac{1}{2} L I^2

  • Inductive Reactance (AC): XL=2πfLX_L = 2\pi f L

Unlike a capacitor, an inductor's resistance to AC current increases with frequency — the opposite frequency behavior of a capacitor's reactance.


4. Component Properties (Property Inspector)

When you select an Inductor on the canvas, you can modify the following parameter in the Property Inspector panel:

  • Inductance (inductance): Sets the coil's inductance in Henries (H).
    • Default: 0.001 H (1mH)
    • Range: 0.000001 H (1µH) to 10 H

5. Programming Notes

Inductors are purely passive analog components and have no associated Blockly blocks. Like a capacitor, an inductor only influences the electrical behavior of connected components — for example, an LC filter's cutoff frequency affects the voltage a board_analog_read block reads on an adjacent pin.


6. Simulator Behavior

  • Real-time Current Readout: While a simulation is running, OMS renders a live text overlay directly on the inductor body — not a hover-only tooltip — showing the current through it (in mA or A) whenever it exceeds ~0.1mA. There's no voltage readout on this component.
  • No Fault Indication: since faults: [] is empty, there's no visual warning state at all for this component — it can't recolor or show a warning label under any operating condition.
Inductor — OMS Parts