Continuous Servo (360°)

A continuous-rotation servo does not hold an angle: the pulse you send sets its speed and direction, and a neutral pulse stops it.

Actuators5 blocksMicroPythonC++
Continuous Servo

At a glance

Pins and properties exactly as the circuit editor and simulator define this part. The text below explains how to use them.

Pinout

Pinout of the Continuous Servo, drawn as in the circuit editor. Select a label to see that pin in the table below.

Pins

Pins of this part
PinLabelType
SIGSIGSignal in
VCC5VPower in
GNDGNDGround

Properties

What you can change in the Property Inspector.

Properties of this part
PropertyRange or choicesDefault
Speed-100 to 100 %0 %

A continuous-rotation servo looks like a standard servo, but it spins all the way round instead of moving to an angle. The control pulse no longer means "go to this angle": it means "turn this fast, in this direction". It is used for small robot wheels and rotating platforms.

How it is controlled

The signal pin takes a pulse train, 50 times a second, like any hobby servo:

  • A pulse of about 1.5 ms is the neutral point: the servo is stopped.
  • A shorter pulse turns it one way, a longer pulse the other way.
  • The further the pulse is from 1.5 ms, the faster it turns.

The simulator follows the Arduino Servo library convention (pulses between about 0.5 and 2.5 ms over a 20 ms period). A pin that is simply held LOW or HIGH is not a command, so a servo with no pulse train on its signal pin stays still.

Wiring

Servo wireConnect to
Signal (SIG)A PWM-capable pin of the board
Power (VCC, 5 V)5 V (use an external supply for bigger servos)
Ground (GND)GND, shared with the board

Blocks

Drawing the blocks…

Troubleshooting

  • The servo creeps when it should be stopped: the neutral point of real servos differs a little; use calibrate, or the trimmer on the servo.
  • Nothing moves: check that the signal pin is on a pin that can do PWM, and that the servo has its own 5 V and a common ground.
Continuous Servo (360°) — OMS Parts